The temperature of a sample of silver increased by 23.8 °C
when 261 J of heat was applied.
What is the mass of the sample?

Cross primary components of vascular tissue are the xylem and phloem. These two tissues transport fluid and nutrients internally. There are also two meristems associated with vascular tissue: the vascular cambium and the cork cambium. All the vascular tissues within a particular plant together constitute the vascular tissue system of that plant.

Answer:

It has its elements with mass numbers phrased in many decimal places, it requires one to round off to get the actual value.

The atomic numbers of some elements such as Protonium were just guessed.

Answer:

Option 1. NO

Explanation:

The balanced equation for the reaction is given below below:

4NH₃ + 6NO —> 5N₂ + 6H₂O

From the balanced equation above,

4 moles of NH₃ reacted with 6 moles of NO.

Finally, we shall determine the limiting reactant. This can be obtained as follow:

From the balanced equation above,

4 moles of NH₃ reacted with 6 moles of NO.

Therefore, 1.24 moles of NH₃ will react with = (1.24 × 6)/4 = 1.86 moles of NO

From the calculation made above, we can see that a higher amount of NO (i.e 1.86 moles) than what was given (i.e 1.79 moles) is needed to react completely with 1.24 moles of NH₃.

Therefore, NO is the limiting reactant and NH₃ is the excess reactant.

Thus, the 1st option gives the correct answer to the question

Answer:

1. NO .

Explanation:

Hello there!

In this case, according to the given information, it turns out possible for us to identify the limiting reactant by simply calculating the moles of any product, say N2, via the moles of each reactant and including the corresponding mole ratio (4:5 and 6:5):

[tex]1.24molNH_3*\frac{5molN_2}{4molNH_3}=1.55molN_2 \\\\1.79molNO*\frac{5molN_2}{6molNO}=1.50molN_2[/tex]

Thus, since NO yields the fewest moles of N2 product, we infer it is the limiting reactant.

Regards!

The element nitrogen exists as a gas  and is  obtained from air on a large scale​ by fractional distillation of air.

An element is defined as a substance which cannot be broken down further into any other substance. Each element is made up of its own type of atom. Due to this reason all elements are different from one another.

Elements can be classified as metals and non-metals. Metals are shiny and conduct electricity and are all solids at room temperature except mercury. Non-metals do not conduct electricity and are mostly gases at room temperature except carbon and sulfur.

The number of protons in the nucleus is the defining property of an element and is related to the atomic number.All atoms with same atomic number are atoms of same element.

Learn more about element,here:

https://brainly.com/question/14347616

#SPJ2

Answer:

greater, two, three

Explanation:

Cations are positively charged ions. In an octahedral complex, the d orbitals undergo greater repulsion and split into 2 high, and 3, low energy groups.

An octahedral complex is a molecular geometry of a compound in which the six atoms are aligned in symmetry around the central metal atom.

The molecule has eight faces and hence is called octa. The two d orbitals present in the structure experience greater repulsive force compared to the three orbitals of d orbit.

Therefore, the d orbit of the molecule has two high-energy orbitals while having three lower energy molecules.

Learn more metal cation here:

https://brainly.com/question/14225650

Answer:

Which scientist developed the first model of the atom that showed the structure of the inside of an atom

Ernest Rutherford

Answer:

Guard cells. The guard cells also contain chloroplast.

Answer:

i think its c because thats when the direction changes and you dont know where he went.                                                

Explanation:

Answer:

The second and the third atomic model.

Explanation:

An element is identified by the no. of protons in the said element. Proton number cannot be changed. Both second and third atomic model have 5 protons, so they are of the same element.

Answer:

NaHSO₄(s) --H₂O--> Na⁺(aq) + HSO₄⁻(aq)

Explanation:

Sodium hydrogen sulfate is a strong electrolyte, that is, when dissolved in water it completely dissociates into the cation sodium and the anion hydrogen sulfate. The corresponding chemical equation is:

NaHSO₄(s) --H₂O--> Na⁺(aq) + HSO₄⁻(aq)

Answer:

flora eat food

Explanation:

because that what every living thing eats to grow.

Answer:

sugar??

Explanation:

plants photosynthesise to make their own food (mainly glucose) to be transported around the plant

Answer:

Draw the curved arrows showing a proton transfer reaction, and draw the products of that proton transfer. Do not include the Li counterion, and lone pairs are not required in the products and the question is hsown below:

Explanation:

The proton from water is abstracted by butyl carbanion and hydroxide ion is formed from water.

The reaction is shown below in the attachment.

Answer:

A) Electrons orbit the nucleus in shells at fixed distances

Answer:

the answer is A

Explanation:

Answer:

When Logan opens a new bottle of carbonated beverage, the sudden release of pressure causes the beverage to bubble up and overflow. What could Logan do in the future to prevent the next bottle from overflowing when he opens it.

Explanation:

This is an application of Boyle's law.

According to Boyle's law:

the volume of a fixed amount of gas is inversely proportional to its pressure at a constant temperature.

[tex]V \alpha \frac{1}{P}[/tex]

So, if pressure reduces all of a sudden, the volume increases and this causes an overflow of the beverage from the bottle.

To avoid this situation, the pressure inside the bottle should not be released at once. The bottle cap should be opened slowly in such a way that opens a little and then close again open a little and then close like that many times if we do, then pressure inside the bottle goes slowly then, the volume will not increase all of a sudden.

Answer:

Cracking.

Explanation:

A chemical reaction can be defined as a reaction in which two or more atoms of a chemical element react to form a chemical compound. An example of a chemical reaction involving hydrocarbons is cracking.

Hydrocarbon can be defined as an organic compound that comprises of hydrogen and carbon only.

In Organic chemistry, cracking refers to the process of lowering the boiling point of a heavy, complex or long-chain hydrocarbon such as kerogens by exposing it to different environmental treatments such as hydrogen enriched catalysts, pressure or high temperatures, in order to produce smaller, lighter and more useful molecules (alkanes and alkenes) such as gasoline, diesel fuel, etc.

Answer:

[tex]\%m=66.7\%[/tex]

Explanation:

Hello there!

In this case, according to the given information, it turns out possible for us to calculate the concentration of the solution obtained, by knowing 20 mL of water are the same to 20 g and therefore the mass of the solution is 40g+20g=60g.

Next, we apply the following equation to obtain the required concentration:

[tex]\%m=\frac{40g}{60g} *100\%\\\\\%m=66.7\%[/tex]

Regards!

Answer:

fe9ufeohdwbkdwsdjvdwihdwkbfw

Answer:

1) Length - Meter

2) Mass - Pound

3) Time - Minute

Please Mark This As Brainliest!

Answer:

Starch.

Explanation:

When the triiodide combine with starch, it forms dark blue colour. Amylose in starch is responsible for the occurrence of a deep blue color when the iodine is combine with the starch. The iodine molecule goes inside of the amylose coil which makes a linear triiodide ion complex that goes into the coil of the starch that leads to an intense blue-black color in the end so we can say that starch turns the colour into blue.

Answer:

Consider the reaction between an alcohol and tosyl chloride, followed by a nucleophile. Write the condensed formula of the expected main organic product.

CH3CH2CH2OH---------- 2.CI 1.TsCl,pyridine__________

Explanation:

Given alcohol is propanol.

When it reacts with TsCl, the hydrogen in -OH group is replaced with tosyl group.

Pyridine is a weak base and it neutralizes the HCl (acid) formed during the reaction.

The reaction is shown below:

Answer:

See explanation

Explanation:

If the spot in TLC is below the solvent front, it will be observed that the spot, instead of being separated by the solvent as expected, will just dissolve away in the solvent and zero actual separation of the mixture is achieved.

If the solute is dissolved away instead of being separated by the solvent, then the experiment fails because no actual separation of the mixture is achieved.

Hence, in TLC, the spot must be applied above the solvent front so that the capillary movement of the solvent through the plate can lead to the eventual separation of the components of the mixture since the various components of the mixture will travel at different speeds through the plate.

Also, if the solvent is above the spot, the solvent may evaporate selectively from the points above the spot while separation is ongoing.

Explanation:

The toxins present are secondary metabolites produced by the fungus. Mushroom poisoning is usually the result of ingestion of wild mushrooms after misidentification of a toxic mushroom as an edible species. ... The safety of eating wild mushrooms may depend on methods of preparation for cooking.

Answer:

A. phosphate group

Explanation:

I got it right in class!

Hope this Helps!! :))

Answer: 6

Explanation:

You would need 6

Answer:

Cuáles son las características de la luz y en qué consisten?

Explanation:

La luz es una radiación que se propaga en forma de ondas. Las ondas que se pueden propagar en el vacío se llaman ONDAS ELECTROMAGNÉTICAS. La luz es una radiación electromagnética

Answer:Matter cannot be created or destroyed in chemical reactions. This is the law of conservation of mass. In every chemical reaction, the same mass of matter must end up in the products as started in the reactants. Balanced chemical equations show that mass is conserved in chemical reactions

Explanation:

sorry it is late but hope it helps!(o゜▽゜)o☆

Answer:

Explanation:

55